Verso

Defect

An incorrect tightening torque was applied at the moment of injector re-installation.

Remedy

Check the injector clamp bolt torque and replace the parts if necessary.

Defect

Possible inadvertent air bag deployment.

Remedy

Replace the airbag sensor assembly.

Defect

The subject vehicles are equipped with right front seat side airbags which may not deploy in a collision as intended.

Remedy

Recall the vehicles that are likely to be affected and replace the right front seat side airbags.

Defect

The subject vehicles are equipped with right front seat side airbags which may not deploy in a collision as intended.

Remedy

Recall the vehicles that are likely to be affected and replace the right front seat side airbags.

Defect

The subject vehicles are equipped with right front seat side airbags which may not deploy in a collision as intended.

Remedy

Recall the vehicles that are likely to be affected and replace the right front seat side airbags.

Defect

Under certain conditions condense water in the intake air can corrode the needle bearing housing. Due to corrosion of the bearing housing the sealing between intake air and the electrical actuator circuit of the throttle body might not be water tight anymore. In the condition that water enters in the throttle body actuator circuit the water might cause a throttle body position misreading or short circuit inside the throttle body electrical actuation mechanism. This might trigger the engine to stall while driving.

Remedy

Recall the vehicles that are likely to be affected and replace the throttle body with a newly designed one. In addition the engine wire harness and the engine ECU will be inspected and replaced if necessary.

Defect

Internal cluctch pistons may have been incorrectly manufacturerd. This may cause incorrect transmission operation.

Remedy

On affected vehicles inspect clutch opertaion. Depending on out come either replace clutch component or transmission unit.

Defect

The resin moulding around the fuel filter water sensor is inadequate. In low temperature environments this can affect the O ring and allow fuel to seep into the sensor. Consequently fuel can then leak out of the sensor through it's breather hole. Additionally maintenance schedules are incomplete.

Remedy

Inspect and replace filter if necessary. Revise maintence information

Defect

It is possible that the nut securing the steering wheel was not correctly tightened when the vehicle was assembled. This could lead to abnormal noise and free play at the steering wheel. If these warnings are ignored the nut could eventually come off and the steering wheel could separate from the steering shaft causing loss of steering ability.

Remedy

Recall the vehicles that are likely to be affected to check the steering wheel securing nut is tightened to the correct torque.

Defect

It is possible for condensation water droplets to form within the relay in the electric power steering control module. This can cause a short circuit across terminals within the relay. If this occurs and abnormally high voltage is detected by the control module it will shut down the power to the EPS which will coincide with a warning buzzer and light illuminating on the dash. This will result in the loss of power assistance to the steering.

Remedy

Recall all affected vehicles and replace the power control module.

Defect

It is possible for condensation water droplets to form within the relay in the electric power steering control module. This can cause a short circuit across terminals within the relay. If this occurs and abnormally high voltage is detected by the control module it will shut down the power to the EPS which will coincide with a warning buzzer and light illuminating on the dash. This will result in the loss of power assistance to the steering.

Remedy

Recall all affected vehicles and replace the power control module.

Defect

There is a possibility that the panoramic roof glass might partially peel from the frame due to insufficient adhesion strength of the paint on the panoramic roof frame. In this condition the roof glass might separate from the frame which could lead to wind noise. If the vehicle is continuously operated the panoramic roof glass may detach from the frame.

Remedy

Inspect and replace if needed.

Defect

It has been identified that on affected vehicles condensation resulting from cold-weather use of the heater or other causes may form on the worn surface of a component within the throttle pedal assembly known as the friction device. If this occurs there is a possibility that in the worst case the accelerator pedal may return slowly or does not return to the engine idle position.

Remedy

Recalled vehicles will have a precision-cut steel reinforcing bar fitted into the accelerator pedal assembly which will create a space in order to reduce the surface tension between the friction device and a component referred to as the pedal arm. The subject bar also strengthens the reaction force of the spring that returns the accelerator pedal to it's non-pressed position.

Defect

Transmission output shaft critical dimension may be shorter than the specification. In the worst case this could result in two gears being selected at the same time and cause the gearbox to lock up.

Remedy

Check transmission serial number and replace any gearbox found to be within the affected range.

Defect

In frequent stop/start conditions in snow and severely cold weather compacted snow/ice may build up on the inner face of the wheel disc. In extreme circumstances the snow/ice may strike and distort the metal pipe that connects to the rear brake cylinder. Impaired braking and a hydraulic fluid leak may result.

Remedy

Fit a modified and re-routed brake pipe.