C Crosser

Defect

Ancillaries drive belt tensioner mounting may not be correct to specification.

Remedy

Check and if necessary replace the ancillaries drive belt tensioner.

Defect

There is a possibility that the sunroof glass assembly could detach itself from the outer frame

Remedy

Replace the sunroof assembly.

Defect

On the affected vehicles the windscreen wiper motor breather system may not be To the correct specification. This could in some cases result in water ingress leading to jamming of the motor due to corrosion. This could cause the wipers to cease operation or not start which in turn could result in restricted visibility for the driver.

Remedy

Replace the windscren wiper motor and one of the windscreen wiper mechanism rods.

Defect

An electronic component within the Built-in Systems Interface (BSI) may not be to the correct specification. This could cause the audio-navigation system the wipers and exterior lighting to malfunction and the warning light on the instrument panel may illuminate.

Remedy

Recall the vehicles that are likely to be affected and check the production date of the BSI unit. Where the production date of the BSI unit is in the affected range the unit will be replaced.

Defect

Brake light switch contacts may become contaminated and the switch may not operate the brake lights when the brake pedal is depressed.

Remedy

Replace brake light switch and clean switch harness on affected vehicles .

Defect

Brake light switch contacts may become contaminated and the switch may not operate the brake lights when the brake pedal is depressed. Ancillary drive belt may fail affecting steering assistance battery charging and air conditioning operation.

Remedy

On affected vehicles; replace brake light switch and clean switch harness; Replace drive belt and if necessary belt tensioner rollers

Defect

Due to the type of material used for the engine drive belt the nylon idler pulley(s) may wear at an angle. With continued use under this condition the drive belt will be forced off the pulleys. This can lead to battery depletion Overheating and on vehicles with hydraulic power steering the steering effort will increase.

Remedy

Replace engine drive belt. Check and if necessary replace idler pulley(s).

Defect

On affected vehicles connectors intended to supply the electric front seats fitted to some versions are not used and are located under the rear footwell carpets. If these connectors come into contact with water of melted snow and de-icing agents they may corrode over a period of time and cause localised electrical overheating.

Remedy

The operation involves repositioning these electrical supply wires for the two front seats to move them higher up on the seat frame.

Defect

It has been identified that due to incorrect operation of the brake servo valve the effectiveness of the assistance provided could be reduced. It should be noted that the brake function remains in operation.

Remedy

Recalled vehicles will have the subject valve replaced.

Defect

It has been identified that the diesel fuel return pipe which is fixed to the inlet manifold may be abraded to the extent that if left undetected will leak.

Remedy

Recalled vehicles as a preventative measure will have the pipe inspected for damage. If any is found the pipe will be replaced. In cases where the pipe remains undamaged it will be fitted with reinforcement.

Defect

It has been identified that there is a risk of the engine stalling under very firm braking conditions.

Remedy

Recalled vehicles will have the engine ECU software upgraded.